PDA

View Full Version : Memory could not be read



Arnor
12-05-2004, 01:31 PM
Hi Friedrich,

This is easy to duplicate:

1. Compile a setup
2. Run it, leave it running, for example waiting on the welcome secreen.
3. Switch back to SB
4. Compile. You will get an error message about not being able to write to the file.
5. Hit the compile button again. This results in "Memory could not be read" error. - see screenshot

Best regards,

linder
12-06-2004, 01:32 AM
Hi Arnór,

Hmm, strange. I get a "The process cannot access the file because it is being used by another process" compiler warning. I'll check this, thank you!

linder
12-06-2004, 06:01 AM
Hi Arnór,

Fixed. If an installation executable is in use during the compilation process, the compiler presents the developer with a retry option that gives the opportunity to close the .exe, and allow the new .exe to be created.

Thanks,

Arnor
12-06-2004, 09:30 AM
Hi Friedrich,

Cool:)

Best regards,