PDA

View Full Version : "Never" Replace file option not working even though the condition option is checked



jgamalinda
06-20-2011, 12:15 PM
Any ideas as to why a file in my installation is getting replaced each time even though I have checked both the conditions and the script to show that this file should NEVER be replaced?
Both the conditions and the script show "[never replace]" but when I run my setup, the file in question keeps getting overwritten.

1. Anyone have any ideas as to why this is happening?
2. Is there any other place in Setupbuilder that I can check to see if any settings to replace a file are set?
3. What does Setupbuilder check when the "Never" replace option is selected?
a. Does it check for just the filename or are there other criteria it checks for when it looks at the file?

Any help would be appreciated.

linder
06-21-2011, 10:37 AM
Thanks for the status update sent to our Support. This was not caused by a SetupBuilder problem.

Friedrich