Is it possible to change the name used for Add/Remove Programs support
at run time? From what I can tell, it uses [PRODUCTNAME] for the name.
There are times when being able to change this might be necessary.

E.g. when you're creating an installer for a Clarion Accessory, it's
quite likely that it will be installed more than once on a machine (a
lot of Clarion developers have both Clarion 6.3 and Clarion 7.1 on their
machines at the moment). If set up with Add/Remove Programs support,
then as far as I know, the last install will overwrite the previous
installs on the Add/Remove Programs List(and only the last one will be
uninstallable via Add/Remove Programs). It would be handy to be able to
change that name to, say '[PRODUCTNAME] for %DETECTEDCLARIONVERSION%',
so that all of the installs show up in a distinctive way.

Ben
- --
Ben Coleman
CTO, Accelerated Design, Inc.
http://www.accelerateddesign.com/