Hi Friedrich,

No idea what has gone wrong. I started with a copy of an install that I
made modifications to, including adding 3 compiler variables and using them
in various places for a more generic install script. There are no errors
posted during compilation, but a few warning about "Wildcard queue is empty"
where it's attempting to pull in files that haven't been added to the source
folders yet. But when I run the install, it crashes immediately with
0x00000005 at address 0x0...01002d943. The original script compiles and
runs without problems. The "Enable Installer Integrity Check" is checked
and there are no errors reported. This happens immediately when it runs.
If I use a "Installer Background" then the background shows, but not the
text on the background.

What is the best approach to start to debug this? I've spent several hours
on this script and I'm not sure if it's better to try to backtrack my
changes until it compiles or start over with the original script?

At any rate, I'm saving the whole project right now to a backup folder in
case you would want to take a peek at it. Just let me know NB: I don't
think I have ever seen a SB compiled install crash before, so I must have
messed something up really good this time!<bg>

Best regards,

--
Arnór Baldvinsson - Icetips Alta LLC
Port Angeles, Washington
www.icetips.com - www.buildautomator.com - www.altawebworks.com
Icetips product subscriptions at http://www.icetips.com/subscribe.php
https://twitter.com/#!/Icetips -
https://www.facebook.com/pages/Iceti...C/177947342793