OK, first off I am using the older code signing (the one that is built
in), so that might make a difference. Also using latest SB release.

I have noticed that if during the made phase, a file fails code
signing the program stops - that is good. However when I run the build
again, it will skip that file that had an error saying that it is
already code signed.

Looking at the file, it is code signed however without a timestamp. So
the build is correct, however would it be possible that if build is
set to timestamp, that is checks to see if the stamp is there and if
not, redo it? Or would it be better just to uncheck the "Skip if
signed" option?

Not a big deal, just like to know.

Barton Whisler
Prosoft Inc.
Tampa, Florida