I'm using SB 6.6.2016. I created an install and was running it on a test
computer (Vista Home Premium) and when I got to the Ready to Install dialog, it
showed the Destination folder as %_SB_INSTALLDIR% rather than the contents of
that variable. I also added an Additional Information Variable that was set to
dieplay the destination data folder. It, too, showed %DATAPATH% rather than
the contents of the variable. You can see it in the attached image named
ReadyToInstall - Vista.gif.
When I ran the same setup.exe on my XP Pro SP2, the dialog displayed correctly
as you can see in the attached image named ReadyToInstall - XP.gif
This is a strange problem and doesn't make sense to me. Any ideas Friedrich?
Peter Gysegem
Beaver Creek Software