If I want to capture what file(s) caused a reboot, I am going to check
the %_SB_INSTALLERFLAG%/$SB_RESTARTFLAG$.

I have reviewed the post dated 3/2/2016, about re-boot because of file
in-use on the Lindersoft forum and the example shows it at the top,
after the 'Initialize Setup' section.

I am assuming that this check can/should be done at the end of my
install script or after all of my 'Install files' commands.

If not, where is the best place to make this check?

Thanks
--
Darrel (Dee) Witham
Professional Data Services, Inc