> I've tried to use the 'set feature' option.
> I've put it after the feature declarations, also just before the loop
> wizard that runs through the dialogs.
> But the option remains unchecked. And when I run the setup, the feature
> is not installed.
> So somehow I'm still doing something wrong I believe.
> Any ideas ?

Hi Hans,

When I need to make changes to items that will appear on a dialog I usually
use the "Set Feature State" in the script editor just before the dialog is
called.

Then I use the "Refresh Next Dialog" option to update the dialog before it
is displayed.

I hope that helps!

Charles

--
-------------------------------------------------------------------------------------------------------
Charles Edmonds

cjeByteMeSpammers@lansrad.com (remove the "ByteMeSpammers" to email me)

www.clarionproseries.com - ProDocument, ImageEx, ProScan, ProImage, ProPath
and other Clarion developer tools!
www.lansrad.com - "Intelligent Solutions for Universal Problems"
-------------------------------------------------------------------------------------------------------