So, Iím working on a huge installation project and when I go to debug it, it seems as if itís reading that the installer is in the installation folder for my SB program. The reason why this is a bit concerning is that I am checking for the existence of an answer file which normally wouldnít be in my set up builder installation directory. Is this expected behavior? Or is what I believe should be happening correct? What I believe should be happening is that when I click debug if itís not already been compiled the installation should compile as if it was a normal install to the location specified and project properties then be run from there. At least thatís what I think should be happening I could very well be wrong.