Reply to Thread

Re: GEN1077 after upgrading to sb10

Friedrich

Re: GEN1077 after upgrading to sb10

Now I'm seriously embarrassed. :-(

[My own copy of SetupBuilder was v7 until I upgraded to 10 on Sunday, but I work part time for the (UK government) Health and Safety Laboratory, and I recommended that they buy it. They did and got v8. I had completely forgotten I had encountered he same problem then! And I *did* search the forum this time without success. So my .sb8 projects on the employer's computer will have the double %, but my own personal ones never needed to get that far! My problem is that I only write installers once every two or three years, and my brain cells don't last that long these days :-( ]

Anyway it has worked again. Thanks.

Re: GEN1077 after upgrading to sb10

Hi David,

SetupBuilder 10 has improved error detection. Please see your post dated 12-10-2014:.

http://www.lindersoft.com/forums/sho...SetupBuilder-8

And this one:

http://www.lindersoft.com/forums/showthread.php?46578

Does this help?

Friedrich

GEN1077 after upgrading to sb10

Trying to compile my previously working .sb7 files after upgrading this week to sb10.

1. Lots of errors told me to use ScriptStructureValidation. Not sure why, but it I did so, and they went away. So far so good. But...
2. I'm still getting a few GEN1077 Syntax Errors (3) in lines setting registry entries. These always worked in sb7.

I attach an image of two of the lines in question. What is going wrong?

Attachment 4341